No, you don't need to open it. Butter Bot arrives fully assembled and ready to use, and nothing in everyday use needs its cover off. Please don't prise off the face plate or unscrew the head. It isn't built to come apart, and you'd be more likely to damage something getting in there.
Looking for the power button? It's the camera on the front of Butter Bot's head. Press the small centre part around the lens (not the outer ring) and hold it for about 3 seconds. A click is normal. See How do I turn Butter Bot on and off?
Charging doesn't need it open either. The battery is built in and charges through the USB-C port, with the cable from the box.
The parts you do handle
The modules click in and out of the module slot. Hold Butter Bot by its head, never its leg, while you swap them. See What does each Butter Bot module do?
The track side covers pop off gently, so you can tighten the track screw if a track slips: A track on my Butter Bot slipped or fell off — what should I do?
The controller and the modules are the do-it-yourself part of the kit, and three modules need a little soldering: Do I need to solder anything on Butter Bot?
Curious what's inside? You can see it without opening anything. Butter Bot's hardware and software are open source, and the schematic of the whole robot, with its top and bottom boards, is in How do I create my own expansion modules? The perf board module is the place for your own electronics.
Something loose or stuck inside? If you hear a rattle, the red light has been pushed in or the camera button sticks, please don't open Butter Bot to fix it. Message us here, or email [email protected] with your order or backer number and a short video or a few photos, and a colleague will look at it with you.