Switching it on. The controller runs on three AA alkaline batteries (not included), or straight from a USB-C cable. With the batteries in, flip its on/off switch to on. The screen starts with a portal picture.
Pairing. Switch Butter Bot on first, then the controller close to it. They pair on their own: see How do I connect Butter Bot to its controller?
Switching it off. Flip the switch back. On a USB-C cable the switch does nothing, because cable power bypasses it, so unplug the cable too. It uses batteries quickly, so switch it off when you have finished.
Butter Bot's own power button is its camera. Press the small centre part around the lens firmly (not the outer ring; a click is normal) and hold for about three seconds until the red light comes on. To switch it off, hold it for three seconds again, or press Summon on the controller and say "Shut down". More in How do I turn Butter Bot on and off?
If the controller switches itself off
Screen flashes up, then goes dark: put in three fresh AA alkaline batteries, all new together. Low or uneven batteries can shut it down right after the portal picture. Avoid rechargeable AAs.
Still the same? Take the batteries out and check for a bent, pushed-in or broken contact, then try the USB-C cable alone. If it works on the cable but not on fresh batteries, message us with a photo of the battery compartment.
Batteries run down fast: that is normal in use. For long sessions, run it from USB-C, which does not use the batteries (or recharge them). See How do I charge Butter Bot and the controller?
It loses Butter Bot: a low battery can make Butter Bot switch itself off and drop the connection, so charge it fully.
It stays on but misbehaves, for example the joystick: see How do I update Butter Bot controller's software?
If that does not help, message us here, or email [email protected] with your order or backer number and a short video of what happens.